![]() ![]() This will allow all the old fluid to drain out.Ģ. Jack up the car and remove the drain plug from the bottom of the transmission. Here’s a step-by-step guide to changing a transmission filter:ġ. ![]() While this is a relatively easy process, it’s important to make sure you do it correctly to avoid damaging your car. If your car is starting to have trouble shifting gears, it may be time to change the transmission filter. If any are found, they should be repaired before continuing to use the vehicleĬan You Change a Transmission Filter Yourself?.Check for leaks around the new transmission filter.Put the new filter in place of the old one, and secure it using bolts or a clip.The old filter can then be pulled out and discarded.This may require removing bolts or undoing a clip.This is usually located near the transmission pan, and may be held in place by bolts or a clip.Be sure to align all bolt holes before attempting to install new bolts hand tighten them as much as possible before using a wrench to finish tightening each one.4ĤReattach your transmission pan using your new gasket and bolts, then carefully pour fresh fluid into your car’s reservoir until it reaches the “Full” line on dipstick. Clean any debris or dirt from both surfaces of the new gasket and lightly coat one side with sealant before attaching it to the transmission pan. Once all of the fluid has drained, remove the old gasket from the rim of the pan and discard it.ģ. Remove the bolts holding the transmission pan in place and lower the pan carefully, allowing the old fluid to drain into the pan. Place a drain pan underneath the transmission pan before loosening the bolts with a wrench.Ģ. Park your car on a level surface and turn off the ignition. Assuming you would like a step-by-step guide on how to change a transmission filter:ġ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |